Replacement IR lamp for Sidel SBO 4/6

Tue, 21 Jul 2026 05:10:35 +0800

Stop Fighting Your SIPA SBO 4/6 Heating

If you’ve spent any time running a SIPA rotary machine, you know the headache of uneven preform heating. One minute everything is fine, and the next you’re staring at wall thickness variations or that annoying pearlescence in the plastic. Usually, the culprit is a “replacement” lamp that isn’t actually a replacement. Here’s the thing: a lamp can look exactly like the original, but if the wattage is off by even 5%, the whole infrared profile shifts. Suddenly, you’re messing with oven timers and praying the bottle quality stays consistent. It’s a frustrating game of guesswork. Getting the power right We don’t do “close enough.” We build these lamps to match your SBO 4/6 specs exactly. If your machine calls for a specific voltage and wattage, that’s exactly what you get. Why does that matter? Because it keeps the heat density steady across the entire zone. You just pop them in and go. No digging into PLC settings, no recalibrating, no stress. It just works. The guts of the lamp We use high-purity quartz glass because these things take a beating with rapid thermal cycling. They use short-wave infrared to punch through the PET quickly, and we make sure the filaments are dead-center. That stops those nasty hot spots from forming on the glass. Plus, we use standard industrial connectors, so you can wire them up fast without worrying about arc-overs at the terminals. A bit of shop floor reality Now, a quick heads-up. Even the perfect lamp can’t fix a dirty machine. If your reflectors are pitted or oxidized, the heat isn’t bouncing back into the preform—it’s just disappearing. You’ll get way more life and performance out of these lamps if you give your reflectors a good clean while you’re swapping them out. One last tip: if you’re pushing these lamps to their limit, your cooling fans are going to work harder. Keep your ventilation clear. Nobody wants to deal with burnt-out sockets in the middle of a shift.

Replacement lamp for SIG Blomax 4/6/8/10

Tue, 07 Jul 2026 11:57:12 +0800

Introduction

We built this replacement lamp for one reason: to fit your SIG Blomax 4/6/8/10 like it was born there. Whether you’re moving from the older SBO models to the new Matrix line, it just works. No rewiring. No machine tweaks. No messing with the socket. It drops in the same way the original did, so you’re back up and running without the headache.

The Nitty-Gritty

This isn’t a run-of-the-mill bulb. It’s engineered to handle the heat and power needed for PET blowing. So we matched the 400V input to the Blomax electrical setup, keeping the current draw exactly where your machine expects it. And the 2500W output gives you the thermal punch to heat preforms fast and evenly. Size matters, too. At 300mm long, the tube fits the tight heating zone of the Blomax series like a glove. That length gives you even coverage across the preform. Cut it short, and you’ll get hot spots. Make it too long, and it won’t even fit the chamber.

4/6 on Infrared Heating Tubes

Replacement IR lamp for Sidel SBO 4/6

Stop Fighting Your SIPA SBO 4/6 Heating

Replacement lamp for SIG Blomax 4/6/8/10

Introduction

The Nitty-Gritty