Why swap your old oven coils for infrared? Most bakery ovens use those old-school resistance wires. They work by heating up the air, and then hoping...

Stop the Bottleneck at Your Bakery Counter We’ve all seen it. The morning rush hits, the line is out the door, and suddenly everything slows down at...

Stop Fighting Your SIG Blomax 4 Heat Distribution If you’ve run a KHS-based blow molding line, you know the headache. One minute everything is...

Stop the Cycle of Burned-Out Tubes on Your SIG Blomax Lines If you’re running SIG Blomax lines, you know the headache. One minute everything is...

Getting the Heat Right for Your Sacmi SBF 12 or Krones Contiform Let’s be honest: PET blow molding is a balancing act. You need enough infrared...

Getting the Most Out of Your Krones Contiform SR 8 Heating Oven Let’s be honest: keeping the heating oven in a Krones Contiform SR 8 dialed in...

Stop Fighting with Uneven Bottles: A Better Way to Heat Your KHS Blow Molders Ever pull a batch of PET bottles off the line and see those annoying...

Fixing Those Annoying Cold Spots in Your Rotary Oven There is nothing more frustrating than pulling a rack out of the oven only to find that the...

Making IR Lamps That Actually Just Work for PET Blow Molding When we design our infrared lamps, we aren’t trying to reinvent the wheel. We just...

IR Heating Lamps that Actually Fit Your Sidel Matrix B2B (and almost everything else) Let’s be honest: nobody likes hunting for specific parts when a...

Can you actually get more out of an old SIPA machine just by swapping the lamps? A lot of people running mid-tier blow molding machines think the...

Stop Fighting Your SIPA SBO 4/6 Heating If you’ve spent any time running a SIPA rotary machine, you know the headache of uneven preform...

Getting the Heat Right in Your PET Blowing If you’re swapping out lamps in a KOSME KSB 4000 or a Husky HyPET, you already know that just...

Getting Your Krones Contiform Lamps Right (Without the Headache) When you’re running a PET blowing line, the last thing you want to deal with...

Getting Your SACMI Rotary Lines Up to Speed If you’re running a SACMI line at full tilt, you know the struggle. Everything has to happen in a...

Stop the Temperature Rollercoaster in Your KOSME KSB 4000/6000 If you’re running SIPA rotary machines, you know the headache of uneven...

Making Shortwave IR Lamps That Actually Fit Your PET Machine When we set out to build replacement shortwave IR lamps for Husky and other big PET...

Stop Letting the Weather Ruin Your Bake If you’ve ever used a portable convection oven on a factory floor, you know the struggle. The minute...

Introduction So, you’re looking at a replacement infrared heating lamp, but not just any lamp. This one is made specifically for the Nissei ASB...

Why We Built This Lamp We built this replacement lamp to handle the heat demands of the Husky HyPET high-speed system. Plain and simple. The goal?...

Introduction We built this replacement lamp for one reason: to fit your SIG Blomax 4/6/8/10 like it was born there. Whether you’re moving from...

On the floor, the SBO8 is pushing your stretch blow molding cycle, day in, day out. You know the drill—when the heater lamps start to lose their...

When the tickets pile up and the line won’t quit, the pass is your last line of defense for texture and temperature. A tired lamp makes food cool,...